Publicidad
Idiomas disponibles
Idiomas disponibles
HIGH PRESSURE NOZZLE WITH SMALL ROUND
BRUSH ( NYLON, BRASS, STAINLESS STEEL )
The high-pressure nozzle can be used with or without one of the small round brushes sup-
plied with the steam cleaner. For items that are particularly prone to scratches, it is best to
use the nozzle without a brush. For all other areas, start with the nylon brush (least abrasive)
and carefully work your way up to the brass, then the stainless steel brush (optional). It is
always better to use care when using the brushes to prevent damage or scratching.
The use of the steam nozzle alone is particularly good for cleaning and degreasing many
working surfaces, ventilation hoods, see through oven doors, ventilation grating, kitchen
furniture, stainless steel or enamel sinks, hand-basins, bath-tubs, water taps (to remove scale
and water residue), doors, metal frames, car wheel rims, pet areas etc.
The nylon brush, because of its softness, is ideal for removing the dirt in grout, sinks and
other surfaces where you need some light scrubbing action, but care must be taken not to
scratch the surface.
Tougher cleaning jobs may require the use of the brass brush that is supplied. Please make
sure you are careful that it does not scratch the surface with this tool. Brass is tougher than
nylon, but softer than stainless steel. For surfaces (grout for example) where the dirt is not
being properly lifted with the nylon brush, carefully using the brass brush may give the best
results.
For the toughest cleaning assignments (very caked on grease, rust, barbecue grills, very dirty
grout), we recommend that you purchase the optional stainless steel brush that is available
through your dealer, or at www.reliablecorporation.com
When using the steam nozzle with or without the brushes, you will need a cloth to wipe up
the moisture and dirt that has been lifted through cleaning.
ATTACHMENT COUPLINGS
If the attachment connections dry up after intensive use, put a small amount of lubricant
(Vaseline) around the O-rings on the male attachment.
FILLING THE TANK
If on the main panel (2), the water level control light (B) comes on during use and you
would like to continue using the steam cleaner, you will need to follow these steps:
1.
Unscrew the black water tank cap (4)
2.
Fill the tank with water (see water instructions for details).
3.
Place the tank cap (4) back on.
If you're using the trolley with the external water bottle connected to the water tank cap,
follow the same steps listed above but directed to the water bottle.
08
Publicidad
