Bosch CS10 Instrucciones De Funcionamiento Y Seguridad página 12

BM 1619X00886 06-12_BM 1619X00886 06-12 6/26/12 7:27 AM Page 12
PLUNGE CUTS
Disconnect the plug from the power source
before making adjustments. Set depth adjust-
ment according to material to be cut. Tilt saw
forward with cutting guide notch lined up with
the line you've drawn. Raise the lower guard,
using lift lever and hold the saw by the front and
rear handles (Fig. 8).
With the blade just clearing the material to be
cut, start the motor. Gradually lower the back
end of saw using the front end of the foot as the
hinge point.
As blade starts cutting the
WARNING
material, release the lower
guard immediately. When the foot rests flat on
the surface being cut, proceed cutting in forward
direction to end of cut.
Allow blade to come to a
WARNING
complete stop before lifting
the saw from cut. Also, never pull the saw
backward since blade will climb out of the
material and KICKBACK will occur.
CUTTING LARGE SHEETS
Large sheets and long boards sag or bend,
depending on support. If you attempt to cut
without leveling and properly supporting the
piece, the blade will tend to bind, causing KICK-
BACK and extra load on the motor
(Fig. 9).
Support the panel or board close to the cut, as
shown in (Fig. 10). Be sure to set the depth of
the cut so that you cut through the sheet or
FIG. 9
WRONG
Turn saw around and finish the cut in the
normal manner, sawing forward. If corners of
your pocket cut are not completely cut through,
use a jigsaw or hand saw to finish the corners.
FIG. 8
FOOT
LOWER
GUARD
LIFT LEVER
board only and not the table or work bench. The
two-by-fours used to raise and support the work
should be positioned so that the broadest sides
support the work and rest on the table or bench.
Do not support the work with the narrow sides
as this is an unsteady arrangement. If the sheet
or board to be cut is too large for a table or work
bench, use the supporting two-by-fours on the
floor and secure.
-12-
LINE GUIDE
FIG. 10
RIGHT