Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTIONS, CONTROL AND DISPLAY ELEMENTS
6
7
8
POWER IN
1
TRUE 1-compatible input socket. Operating voltage: 100–240 V AC / 50–60 Hz.
POWER OUT
2
TRUE1-compatible output socket to supply power to additional CAMEO spotlights. Ensure that the total
power consumption of all devices connected to the device does not exceed the given ampere (A) value.
FUSE
3
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT NOTE: Exclusively replace the fuse with a fuse of the same type and values
(T3,15A/250V). If a fuse trips repeatedly, please contact an authorized service center.
4
DMX IN
Male 5-pin XLR connector to connect a DMX control device (e.g. DMX console).
DMX OUT
5
Female 5-pin XLR connector to transmit the DMX control signal.
OLED DISPLAY
6
Display for the currently active operating mode and the menu items in the processing menu.
7
DIM / ENTER / SELECT
Push button rotary encoder to set and control the spotlight.
DIM - When used in CCT, HSI, Direct LED, Gel, User Color or Play Loop stand-alone mode, the encoder serves as a master dimmer (rotary encoder).
ENTER - 1. Pressing ENTER brings you to the menu level to select the mode. 2. This navigates you one level deeper
into the menu structure. 3. Confirm the new value, such as a change to the DMX address, by pressing ENTER
SELECT - Rotate the encoder to select the menu item from the menu level and change the value within the menu item (such as DMX address).
8
The function of the center push button rotary encoder (rotate and press) is shown on the corresponding menu item at the center of the
display (middle row = rotate, lower row = press).
ESC - If the press function on the right push button rotary encoder is not shown explicitly in the display, then pressing the encoder
9
navigates to the next higher menu level.
10
ZOOM
The adjustment knob for manually adjusting the beam angle is located on the right side of the housing. The yellow bell-shaped knob is
located directly opposite the adjustment knob and is used for manually adjusting the beam angle using an operating pole for crossbeam
installation. The adjustment knob and drive unit for the operating pole are mechanically connected to each other. The adjustment knob or
yellow bell-shaped knob can be turned to continuously adjust the spotlight beam angle between 53° and 17°, with the zoom tube on the
Fresnel lens moving in and out of the housing through a gear-and-pinion system. The further the zoom tube emerges from the housing, the
smaller the beam angle. A stopping mechanism is in place to prevent the tube from falling out of the housing.
10
9
备注
3
1
2
受 控 正 本
受控 副 本
4
5
单 位 章
客 户
A H
5
AH
Publicidad
