Publicidad
Idiomas disponibles
Idiomas disponibles
transmission. Freewheel control is at the rear
drawbar of the product.
1. Lift the attachment to the highest position with
the attachment lift control.
2. Pull the freewheel control out and into the slot
and release to hold it in the disengaged position.
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more,
tacky particles can cause blockage in the carburetor.
This has a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Run the engine for a minimum of 10
minutes after you add the stabilizer until it flows into
the carburetor.
WARNING:
product with fuel in the tank in an indoor
location or in locations with bad airflow.
Risk of fire if fuel fumes come near
open flames, sparks, or pilot lights in
for example boilers, hot water tanks and
clothes dryers.
WARNING:
and other flammable materials from the
product to decrease the risk of fire. Let
•
Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
•
When the product is worn out, send it to the
dealer or to an applicable recycling location.
•
Oil, oil filters, fuel and the battery can have
negative effects on the environment. Obey
2010 - 003 - 10.04.2023
Storage
Do not keep the
Remove grass, leaves
Disposal
3. Do not move the product at more than two (2)
mph (3.2 km/h).
4. To reengage transmission, reverse the above
procedure.
Tow safety
•
Only use tow equipment approved by
Husqvarna.
•
Use the tow bar to attach the equipment.
•
Do not tow equipment that is heavier than the
maximum permitted weight.
•
Make sure that no other persons is near the
product when you tow equipment.
•
Do not tow equipment on slopes or rough
ground.
•
Operate the product at low speed when you tow
equipment.
the product become cool before you put
it in storage.
•
Clean the product, see
on page 24 . Repair paint damages to prevent
corrosion.
•
Examine the product for worn or damaged parts
and tighten loose screws and nuts.
•
Remove the battery. Clean it, charge it, and keep
it cool during storage.
•
Change the engine oil, and discard the waste oil.
•
Empty the fuel tank. Start the engine and run it
until there is no remaining fuel in the carburetor.
Note:
Do not empty the fuel tank and
carburetor if a stabilizer has been added.
•
Remove the plugs and put about a tablespoon of
engine oil into each cylinder. Manually turn the
engine shaft to apply the oil and put the plugs
back on.
•
Lubricate all grease nipples, joints and axles.
•
Keep the product in a clean and dry area and
cover it for more protection.
•
A cover for protection of your product during
storage or transport is available at your dealer.
the local recycling requirements and applicable
regulations.
•
Do not discard the battery as domestic waste.
•
Send the battery to a Husqvarna service agent
or discard it at a disposal location for used
batteries.
To clean the product
39
Publicidad
