Publicidad
Idiomas disponibles
Idiomas disponibles
3. Wash with cold water only. DO NOT
use detergent or soap. Squeeze by hand
and allow to air dry. Allow all filters to
dry 24 hours before putting back into
vacuum cleaner.
NOTE:
DO NOT operate without foam
and felt filters installed.
DO NOT wash in the dishwasher.
DO NOT install foam and felt filters if
damp.
WARNING
Always unplug power cord from
electrical outlet before performing
maintenance to the vacuum cleaner.
Replace belt whenever a burning rubber
smell caused by excessive slippage occurs.
NOTE:
Make sure that the pile height
setting is on the LOW setting.
1. Lay the vacuum cleaner on floor with the
bottom up and the floor nozzle flat.
2. Use a Phillips head screwdriver to
remove the six screws from the belt
cover and the lower plate.
FOAM AND FELT FILTERS CLEANING
BELT CHANGING
4. Replace foam and felt filters into the
vacuum cleaner.
Foam Filter
Felt Filter
5. Reinstall the dust cup. See EMPTYING
DUST CUP (page 18).
Belt Cover
- 20 -
Lower Plate
Publicidad
