Publicidad
T EC HN I C A L I N FO RMATIO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
10001001, 10103001
10003001
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing codes
when setting the temperature on the water heater.
I NSTALL ATI ON CO N SIDE R ATION S
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ #10001001 ONLY: The drain is suitable for most,
but not all, lavatory sinks sold in the United States
and Canada.The drain is intended for use in a sink
with an overflow. If your sink does not have an
overflow, or if this drain is too small for the hole in
your sink, please refer to the instructions included
with the sink. Some sinks include special drain
installation instructions and/or parts. Others require
the use of a specialty drain. Hansgrohe is not
respnsible for the cost of a specialty drain.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
0.5 GPM (1.9 L/min)
1⅜" (34 mm)
1⅝" (40 mm)
E N G L I S H
⁄ #10103001, #10030001 ONLY: This faucet does
not include a drain or a pull rod.
⁄ The hot and cold supply hoses included with this
faucet are for use with ⅜ stops. If your stops are
a different size, purchase adapters at your local
plumbing supply store or home center. Adapters are
not available from Hansgrohe.
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
