Publicidad
Idiomas disponibles
Idiomas disponibles
EN Operating Instructions
Contents
I.
IMPORTANT SAFETY REGULATIONS
II.
TECHNICAL DATA
III.
UNPACKING AND PRELIMINARY CHECKS
IV.
WHERE TO POSITION THE AQUARIUM
V.
INSTALLING AND SWITCHING ON THE AQUARIUM
VI.
OPERATING AND CLEANING
VII.
MAINTENANCE
VII.
TROUBLESHOOTING
EN
VIII.
CORRECT DISPOSAL OF THE PRODUCT
IX.
WARRANTY
SPARE PARTS AND ACCESSORIES
I. IMPORTANT SAFETY REGULATIONS
This appliance is intended for use as a fresh or marine water aquarium in homes. Any other use is not permitted
and therefore the manufacturer shall not be held liable. NEWA Mirabello complies with safety regulations
EN60598-2-11, the pump complies with the EN60335-2-41 standard. The aquarium has been designed and made
in order to guarantee safe use throughout its life cycle. Nevertheless, improper use of the aquarium (use not
compliant with the provisions of this manual) may cause damage to the aquarium and compromise user safety.
WARNING: the symbol on the label of NEWA Mirabello young indicates that you must thoroughly read this operating
instruction manual before starting up, operating or carrying out any maintenance operations on the appliance.
WARNING: during installation and maintenance, disconnect the aquarium and all its accessories from the electrical mains. Do
not connect the aquarium to power sockets unless it is completely filled with water.
To avoid any kind of accident, carefully follow the simplest safety provisions and the following warnings:
1) CAUTION: This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance because this is not a toy. Cleaning and user
maintenance shall not be made by children without supervision.
2) WARNING: turn off and disconnect all the electrical equipment in the aquarium before carrying out
any maintenance tasks.
3) The power cord must not be repaired or replaced. If it is damaged, replace the entire accessory
(pump). If the power cable for the aquarium light is damaged, the entire light unit must be replaced.
4) Read the warnings and observe the symbols on the labels of all electrical appliances and in the instructions.
5) Pour in the water up to the desired level, making sure that the maximum water level does NOT exceed the indicator on the
upper edge to the aquarium (fig. 1).
6) Check that the voltage printed on the label inside the aquarium lid, on the pump and also on the heater, if included, to make
sure it corresponds to the main power supply.
7) Do not insert the plugs of the appliances before completely filling the tank with water.
8) Check that all the electrical accessories have no knocks or marks indicating falls or crushing.
9) The power supply cables should be inserted in the socket so that a part of the cable forms a loop at a lower level than the
socket. This will prevent water droplets from entering the socket (Fig.2) by running along the cable.
10) Always disconnect the plugs when the aquarium is not in use, before inserting or removing its components and before
cleaning. Do not try to disconnect from the socket or the plugs of the appliances by pulling the cable, but disconnect it by hand.
11) Do not touch the power plugs with wet hands or touch the plugs with your bare hands if they are wet.
page 10
page 11
page 14
page 14
page 14
page 15
page 31
page 15
page 16
page 16
page 3
14
Publicidad
