Publicidad
Horse and cattle shearing machine GT474(K) / GT677(K) and cutter head GT367
4. Operation
DANGER
Risk of death by electric shock!
Do not open the product.
Connect the product only to a grounded power
supply.
The appliance shall never be left unattended when plugged in.
Never operate this appliance when it has a damaged cord or plug,
when it is not working properly, after it has been dropped or
damaged, or after it has been dropped into water.
Do not reach for an appliance that has fallen into water. Unplug
immediately from receptacle.
Return the appliance to a service center for examination and repair.
Keep the cord away from heated surfaces.
Do not use while bathing or in a shower
Do not place or store appliance where it is able to fall or be pulled
into a tub or sink. Do not place in or drop into water or other liquid.
Except always unplug this appliance from the electrical outlet
immediately after using.
Keep the air openings free of lint, hair, and similar objects.
Never drop or insert any object into any opening.
Do not use outdoors or operate while aerosol (spray) products are
being used.
Do not use this appliance with a damaged or broken comb, as it has
the potential to result in facial injury.
Attach the plug to the machine first, then to outlet.
Before plugging in and switching on the machine, check to ensure
that the voltage on the rating plate is in accordance with the
voltage at your site.
The machine can be switched on and off with one hand by means
of the sliding switch 51, which is located midway between the two
ends of the machine (see fig.).
To disconnect the machine, slide the slide switch 51 to the off
position and then remove plug from outlet.
WARNING
Do not charge, place or leave the appliance where
it is expected to be:
Subject to damage by an animal, or
Exposed to weather.
CAUTION
Do not under any circumstances switch on the
machine if it has not been properly fitted out
with cutter plates!
Always unplug the machine before carrying out
any maintenance work on it.
Always lay the machine on a dry surface, and
store it in a dry place.
Please note
The overload switch shuts the machine down if there is excessive
pressure on the plates, if the cutting head is jammed, or if the motor is
malfunctioning. When the overload switch is activated, the head of the
switch pops out of the back of the motor cover.
Inspect the machine with the plug disconnected from the socket, and
eliminate the cause of the shutdown. The overload switch can be
turned back on after a few minutes by pressing the head of the switch,
which is at the back of the motor.
5. Oiling the cutter head
Important
Oil the machine only while it is running!
Never immerse the machine or the cutter head in liquid of any kind.
Use light machine oil, order no. GT604.
Oiling hole A should be kept well-oiled, depending upon the animal
(see fig.).
The swing blade 10 should be oiled 2-3 times daily with 3-4 drops
of oil (see fig.).
6. Greasing the gear wheel
Use only gear grease GT605!
1-2 times per shearing season apply approx. 1 cm of grease to
opposing points on the gear wheel 11 (see fig.).
Remove the cutter head (see section 9).
11
Publicidad
