Descargar Imprimir esta página

cecotec 05612 Manual De Instrucciones página 21

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
ENGLISH
If scale is built up due to the use of hard water, it is recommended to:
Use cold boiled water or distilled water.
Clean the transducer, water tank and basin humidifier every week.
Change the water in water tank more often to keep it fresh.
Make sure to pour out water from the water tank and dry the water basin before you store it
unused for a long time.
Clean the whole humidifier and make sure that all parts of the humidifier are dried completely
if it is supposed to be leaved unused for a long time.
Cleaning the transducer
Clean with clean water or citric acid if there is scale in it.
Brush off the scale from the surface.
Rinse the transducer with clean water.
Cleaning the humidifier basin
Clean the water basin with soft cloth or use citric acid if there is scale in it.
If there is scale covering the security switch, drop citric acid for 2-5 mins on the scale and
clean it out with the brush.
Rinse the water basin with clean water.
Cleaning the ceramic filter
Clean the ceramic filter after using 1000L of water regularly. (This is approximate and
depends on water quality).
If the ceramic ball is dirty, it needs to be cleaned more frequently.
It can be dipped in vinegar about 5 minutes. Then rinse it with clean water.
Place the filter under the sun for 4~6 hours.
5. TROUBLESHOOTING
Trouble
Possible cause
The humidifier is not plugged
in.
The light indicator is
off when switched
Power cord is damaged.
on
Humidifier is defective or
malfunctioning.
40
BREEZECARE 3500 WARM
Solution
Plug the humidifier into a powered
electrical socket.
Stop using the device immediately
and contact the Technical Support
Service of Cecotec.
The light indicators
Humidifier is not turned on.
is on when switched
on, but no mist
The target humidity is reached.
comes out
No water in the tank.
Water level is low.
The water level required
has not yet reached the
vaporisation compartment.
Water shortage
The water tank isn't well
indicator is on
positioned.
The humidifier isn't on a flat
surface.
The % RH of the room is over
90 %.
Humidifier is new.
Dirty water or water sitting
Humidifier produces
too long.
an unusual smell
Residual smell from diffusing
aroma oil on the aroma cotton.
Resonant in water tank when
water is too low.
Humidifier is on an unstable
surface.
Humidifier makes
a loud or unusual
Water tank is positioned
sound
incorrectly.
Humidifier is malfunctioning.
ENGLISH
Press the power button to turn
it on.
Increase the target humidity or
change mode.
Refill the water tank and wait at
least 1 minute.
Wait at least 1 minute.
Check the positioning of tank on
the base.
Check the positioning of the
humidifier.
Wait until the % RH gets lower.
Take out water tank, open cover,
let it stay 12 hours in cool position.
Clean water tank, fill with clear
water.
Remove the aroma cotton, rinse
it under clean water and allow it
to dry.
Fill water into water tank.
Move the humidifier to a stable
flat surface.
Turn off and unplug the humidifier,
then align the water tank cover
with its respective opening in the
inner chamber.
Stop using the device immediately
and contact the Technical Support
Service of Cecotec.
BREEZECARE 3500 WARM
41

Publicidad

loading

Este manual también es adecuado para:

Breezecare 3500 warm