Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACEMENT OF WICK
CAUTION: Before changing wick, ensure unit is
turned OFF and unplugged.
NOTE: This unit uses model SGL1040 wick.
Replace the wick at the beginning
of each season, after every 30 to 60 days of
operation and more often in areas with hard water.
1) To replace wick, lift off the chassis.
2) Remove the used wick and replace with a fresh
wick.
ABOUT HUMIDITY
Where you set your desired humidity levels depends
on your personal comfort level, the outside
temperature and the inside temperature.
NOTE: Recent CDC tests show that the chances of
flu transmission are greatly reduced at levels of 43% humidity.
You may wish to purchase a hygrometer* to measure the humidity level in your
home. The following is a chart of recommended humidity settings.
When Outdoor
Temperature is:
°F
° C
-20
-30°
-10°
-24°
2°
-18°
10°
-12°
20°
-6°
30°
-1°
NOTE: External hygrometer readings and humidistat readings may differ. Humidity
levels can vary significantly even in one room. The amount of time it takes to affect
the room humidity depends on the relative humidity of the air. In especially dry areas
it could take up to 48 hours to see humidity climb to the desired level.
*Model 1990 digital hygrometer is available for purchase by calling 1-800-547-3888, or visit
www.aircareproducts.com
CONTROLS AND OPERATION
NOTE: The humidifier should be placed at least FOUR inches away from any walls or
curtains, and away from heat registers. Do not place on soft carpet. Unrestricted
airflow into the unit will result in the best efficiency and performance.
MODELS CM330A (ANALOG CONTROL PANEL)
Recommended
Indoor Relative
Humidity (RH) is
15 - 20%
20 - 25%
25 - 30%
30 - 35%
35 - 40%
40 - 45%
1) Turn the unit on by turning the speed knob to the
first speed.
2) This fan knob has three speed settings, High,
Medium and Low. Turn the knob clockwise to
decrease speed.
3) The humidity level knob is located above the fan
speed knob. Increase humidity by turning the upper
knob clockwise.
5
IMPORTANT: Water damage
may result if condensation
starts to form on windows or
walls. Humidity SET point
should be lowered until
condensation no longer forms.
We recommend room
humidity levels do not exceed
50%.
Publicidad
