Cutting Paper; Malfunction And Remedy - Microlife PR 1KA1 Instrucciones De Uso

4.6. Cutting paper

Once you finish the printing job, check the paper to
see if it is easy to tear off.
• If it is not long enough to tear off, please depress
the "Paper Feeding" button to lengthen the paper.
Note:
• Don't pull out the paper if you'd like to cut it.
• Try to lower down the paper, pulling it forward over
the paper cutter.
• The paper has to be vertical (90 degree) with the
paper cutter; otherwise, the paper will be difficult
to tear off.
• The print on the paper does not last forever. It fades over time. This is normal for
thermal printers such as the Microlife diagnostic printer. The readability lasts
longer the less the print is in contact to light. If you file the printed paper in a
folder, the print lasts very long. In case you would like to store the values forever,
we recommend to photocopy them or transfer the data to another media.

5. MALFUNCTION AND REMEDY

If problems occur when using the printer, the following points should be checked and
if necessary, the corresponding remedies taken:
Malfunction
The LED remains flashing while
the printer is switched on
although the batteries are
good.
Clicking the printing button on
the monitor, but nothing prints
There's no response for paper
feeding
Remedy
1. Check whether the batteries are installed with
the correct polarity.
2. If the LED is unusually flashing, remove the
batteries and re-install them or exchange them
for new.
1. Check whether the cable is connected with the
monitor and printer.
2. Examine whether the paper is positioned properly
ready for printing.
1. Examine whether the paper is positioned properly.
2. Check if the paper roll has been exhausted, and
needs to be replaced by a new one.
90 °
Paper cutter
LED dark LED bright
7