Dyna-Glo EG10000DGP Manual De Instrucciones página 5

LOCATING HEATER
INSTALLATION
MOUNTING THE BRACKET
Refer to Figures 4a and 4b.
1. Locate a wood stud in the wood ceiling joist. If you cannot locate a wood
stud, you have to install a wood piece on the ceiling as this heater must be
securely fastened.
2. Remove the mounting bracket from the heating unit by loosening bracket
screws with a wrench and slipping the handle off over the screw heads.
3. Place a washer on screws before inserting through the holes in the mounting
bracket and screw them securely into a ceiling joist. It is suggested to drill a
15/64 size pilot hole.
NOTE: If you want to swivel the heater either to the right or left adding a washer
to both sides of the bracket is recommended. A longer lag bolt may be required to
properly secure the unit. See Figure 4a.
HANGING THE HEATER
1. Attach the heating unit to the mounting bracket.
2. Lift the heater up and into the mounting bracket.
3. Align the bracket screws with the keyhole slots in the mounting bracket.
4. If the heater is to be tilted it must be positioned in the keyhole slots - see
figure 5.
5. Tighten the bracket screws with a wrench so the unit is securely suspended
at horizontal or vertical level.
Wood Ceiling
Figure 3
Wood Ceiling
5