CARLO GAVAZZI CA18FA Manual De Instrucciones página 22

Idiomas disponibles

2.6.8. Quality of Teach QoT

The quality of Teach value lets the user know how well the actually the tteach procedure was carried

out, in terms of the margin between the actual setpoints and the environmental influences on the

sensor.

The value for QoT can vary from 0 ... 255 %.

The QoT value is updated after every Teach procedure.

Examples of QoT are listed in the table below.

Quality of teach value Definitions

> 150%

100%

50%

2.6.9. Filter Scaler

This function can increase the immunity towards unstable targets and electromagnetic disturbances:

Its value can be set from 1 to 255, the default factory setting is 1.

A filter setting of 1 gives the maximum sensing frequency and a setting of 255 gives the minimum

sensing frequency.

2.6.10. LED indication

The LED indication can be configured in 3 different modes: Inactive, Active or Find my sensor.

Inactive: The LEDs are turned off at all times

Active: The LEDs follow the indication scheme in 5.1.

Find my sensor: The LEDs are flashing alternating with 2Hz with 50% duty cycle in order to easily

locate the sensor.

Excellent teach conditions, the sensor is not expected to have any

maintenance issues.

Good teach conditions, the sensor has been taught with a safety mar-

gin of twice the standard hysteresis.

• Long term reliability is expected for all environmental conditions.

• Maintenance is not expected to be required.

Average teach conditions.

• Short-term reliability and maintenance is expected due to environ-

mental conditions.

• Reliable detection can be expected with restricted environmental

influence.

Poor teach result.

• Unreliable working sensing conditions are expected. (e.g. too small

measuring margin between the target and the surroundings).

Ca30fa