Descargar Imprimir esta página

Weelko MultiEquipment F336A Manual De Instrucciones página 9

Ocultar thumbs Ver también para MultiEquipment F336A:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

MICRO-CRYSTAL DERMABRASION
Instructions of use
1. Assembly the plastic handle holder in on side of the
device.
2. Properly plug the pipes as shown in the sketch
below. Match each letter on the pipes with each letter
on the containers. Just introduce them and do gentle
pressure. To withdraw the pipes, press the round
plastic part in the plug and pull the pipe without
forcing.
C
3. . Fill with micro-crystals the container #2 without
exceeding the line. The cap thread must be completely
clean of micro-crystals. #120 particle size
micro-crystals are recommended to be used.
Important note:
Please check that the head of the handle is not
blocking the hole inside.
Is prohibited manipulate micro-crystal with hands.
4. Select the desired power output and time of working
by pressing "ENERGY" and "TIMER" respectively.
"ENERGY" can be adjusted between 1 and 10. "TIMER"
can be adjusted between 1 and 60 minutes.
5. Press "START/PAUSE" button to start. The display
indicates the machine is working normally. The
operation can be paused and restarted by pressing
this button.
6. Once the operation time is finished, the device will
beep and the selected function will stop. The device is
now in standby mode.
7. Once the treatment is finished, micro-crystals are
C
A
B
deposited in the container #1. On the contrary,
container #2 is empty. Remove and discard the used
micro-crystals.
Fill the container #2 for future treatments. The cap
thread must be completely clean of micro-crystals.
Notes
During the treatment, always keep the handle under
the device level. Do not work with the handle over the
device level.
The direct contact to the skin is 3–5 seconds only.
After this time, lift the handle and apply it to another
part of the treatment area.
Cautions
Clean and dry skin. No need to apply lotion for
treatment.
During the operation on the eyes, please adjust the
air pressure about 1-5 , and it will be enough after
gently hand over twice.
Avoid sun exposure for 24 hours after treatment.
Do not use makeup for 4 hours after treatment.
Do not make sauna sessions during the 10 days after
treatment.
After treatment, use neutral products to moisturize
the skin rather than acidic.

Publicidad

loading