Progress Lighting P250021 Manual De Instalación página 12

CAUTION: Before starting installation, disconnect the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power off using the fan switch is not sufficient to prevent
electric shock.
1. Remove 1 of 3 screws from the mounting plate and loosen the other 2 screws. (Do not remove)
2. While holding the LED light kit under the fan motor assembly, make the 2-pin wire connections:
- White to white
- Black to blue
3. Place the key holes in the LED light kit over the two mounting screws previously loosened from
the mounting plate. Turn the LED light kit until the LED light kit locks in place at the narrow
section of the key holes. Secure by tightening the two screws previously loosened and the one
previously removed. (Fig. 17)
4. Raise the glass shade (or metal light cover) up against the LED light kit and secure it to the fan
by turning the glass shade clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 17)
9. Installing the Light Kit and Glass Shade
Wire connector
LED
Light kit
Figure 17
Mounting
plate
Screws
Glass
shade