Satco NUVO S49390 Instrucciones De Instalación Y Seguridad

HI-PRO LED LAMPS
Models: S49390, S49391, S49392, S49393, S49394, S49395
S49396, S49397, S49670, S49671, S49672, S49673, S49674
S49675, S49676, S49677, S49738, S49739
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Luminaire wiring and electrical parts may be damaged when drilling for installation of
LED retrofit. Check for enclosed wiring and components.
• LED Retrofit installation requires knowledge of luminaires electrical systems. If not
qualified, do not attempt installation. Contact a qualified electrician.
• Install this lamp only in luminaires that have the construction features and dimensions
shown in the photographs and/or drawings and where the input rating of the retrofit
does not exceed the input rating of the luminaire.
• Do not make or alter any open holes in an enclosure of wiring or electrical components
during kit installation.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
or other sharp objects.
• Disable all power to the Luminaire. The lamp holder must be disconnected from the
wiring to the ballast, capacitor, or ignitor. Verify that voltage does not exceed 277V AC.
Please see "Wiring Diagram".
• Failure to follow instructions can result in a damaged product and will void warranty.
It could also result in an electric shock or fire.
IMPORTANT:
• Added weight of the device may cause instability of a free-standing portable luminaire.
• Installers should not disconnect existing wires from lampholder terminals to make new
connections at lampholder terminals. Instead installers should cut existing lampholder
leads away from the lampholder and make new electrical connections to lampholder
lead wires by employing applicable connectors.
INSTALLATION
STEP 1: Turn off the power before
installation.
STEP 2: Remove the old Ballast,
Capacitor and Ignitor (if existing).
STEP 3: Make sure Alternating
Current Wires connect to the
socket directly. Reattach or
replace ground lead (if necessary).
STEP 4: Screw the LED lamp into
the corresponding socket. Attach
retrofit label to luminaire.
NOTES: For 100-277 Volts
applications with two hot leads,
connect the second hot lead to
terminal N (L1).
© Copyright 2021 Satco Products, Inc. 11/21 v1.2
WIRING DIAGRAM
Replacing CFL Lamp
(L1)
CFL Wiring Diagram
Replacing HPS/HID Lamp
Capacitor Ignitor
(L1)
HPS/HID Wiring Diagram
(L1)
Hi–Pro Wiring Diagram
Capacitor Ignitor
(L1)
Hi–Pro Wiring Diagram
Satco Products, Inc.
Brentwood, NY 11717