Settings; Changing The Direction Of Rotation; Changing Gear - Festool T12+3 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3-2
The charger TRC 3 can be used to charge all Festool
battery packs of the BPS and BPC series. The
charger automatically detects the type of the in-
serted battery (NiCd, NiMH or LiIon). A micropro-
cessor controls the charging process in line with
the charging state, temperature and voltage of the
battery pack.
If a warm NiMH battery pack (> 37 °C) is inserted,
the pack is charged with a reduced charging cur-
rent and will take longer to charge.
The LED [3-2] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack is charged to maximum capacity.
LED green - flashing slowly
Battery pack is charged with reduced current, LiIon
is charged to 80 %.
Consider the pictures on the fold-out page.

Changing the direction of rotation

The right/left switch [1-4] changes the direction of
rotation.
• Move switch from right to left = clockwise rota-
tion
• Move switch from left to right = anticlockwise ro-
tation

Changing gear

Always switch off the machine before changing
gear!
You can change gear using the gear switch [1-6].
• Switch forwards (Number 1 visible) = first gear
• Switch backwards (Number 2 visible) = second
gear
LED green - lit continuously
3
Battery pack is fully charged, or charging is not
started again, because the battery is charged to
more than 80 %.
LED red - flashing
General fault display, e.g. incomplete contact, short
circuit, battery pack faulty, etc.
LED red - lit continuously
Battery temperature is outside the permitted
range.
3-1
Charger wall mounting TRC 3
There are two elongated holes on the back of the
TRC 3 for mounting the charger to a wall using two
screws (e.g. round head or flat head screw with
shank diameter of 5 mm).
Insert the two screws into the wall at a distance
of 96 mm from one another and leave the screw
heads protruding approx. 4 mm.
4 mm/
0.16''

Settings

The drilling/fastening selector switch [1-9] is set to
the screw symbol marking [1-8] = torque is adjust-
able.
The switch-over function only works if the ma-
chine is switched off.
Set the correct torque using the torque thumb-
wheel [1-12]:
Setting on 1 = low torque
Setting on 25 = high torque
The machine switches off when the preset torque is
reached and an acoustic signal sounds. You must
release and press the ON/OFF switch [1-3] again to
start the machine.
96 mm/
3.78 ''
Fastening
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

T15+3T18+3C 12 liC 15 li

Tabla de contenido