Craftmade Eastwood Guia De Instalacion página 9

9. LED Light Kit Assembly. (cont.)
If you do NOT wish to use the light kit,
slots on metal cover and align with nodules
inside LED light kit. Gently push up on metal
cover and turn to the
no longer turns.
WARNING: Metal cover will be HOT if light is left
on.
10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10
for remote control assembly instructions. If you
have already installed the wall control but do not
wish to use the handheld remote control, please
proceed to Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
The dimmer switch (labeled ON and D) has
been pre-set to the "ON" position (ON). If you
do not wish to have dimming capability, please
move the switch to the "OFF" position (D). [Refer
to diagram 2.]
Align holes in wall control with posts located
on inside of TOP part of remote control cover
and press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [Refer to diagram 3 on the
next page.]
["Handheld Remote Control Assembly"
continued on next page.]
locate
RIGHT (clockwise) until it
metal
cover
diagram 1
dimmer
switch
diagram 2
page 9
nodules
grooves
remote control
cover
(top)
(bottom)
wall control
wire
IV
I I I
I I V
VI
I
wire
wire
12V battery