Publicidad
Idiomas disponibles
Idiomas disponibles
English
THE SCOPE AND SUGGESTIONS FOR USES
Work
Wood
Drilling
Steel
Aluminum
Machine
screw
Screw
tightening
Wood
screw
HOW TO SELECT TIGHTENING TORQUE
Clutch dial
position
1
Approximately 9 in.-lbs. (10 kg-cm)
3
Approximately 15 in.-lbs. (17 kg-cm)
7
Approximately 23 in.-lbs. (26 kg-cm)
13
Approximately 35 in.-lbs. (40 kg-cm)
17
Approximately 43 in.-lbs. (49 kg-cm)
22
Approximately 52 in.-lbs. (60 kg-cm)
High speed: approximately 106 in.-lbs (122 kg-cm)
Low speed: approximately 400 in.-lbs. (459 kg-cm)
NOTE
The selected content shown in Table 4 indicates
the differences according to screw type, screw size
and material used.
CAUTION
●
While operating the Cordless driver drill, take care
not to lock the motor.
If the motor is locked, immediately turn the power
off.
If the motor is locked for a while, the motor or
battery will be burnt.
●
Do not tighten too strongly as the screw heads
will be damaged.
18
Table 5
Clutch dial position
1 – 22
1 –
Table 6
Tightening torque
Suggestions
Use for drilling purpose.
Use the bit and socket matching the
screw diameter.
Use after drilling a pilot hole.
Machine screw
tightening Screw
tightening for soft wood
material
Screw tightening for hard
wood material
Thick screw tightening
When used as a drill.
Operation example
Publicidad
