SOLAC AE2502 Instrucciones De Uso página 9

ENGLISH
Stick vacuum cleaner
Blank Canvas
DESCRIPTION
A Accessory 2 in 1:
A-1 Accessory for furniture and upholstery
A-2 Lance and brush
B Outlet filter lid
C Aluminium extensión tube
D Motorized brush
E Brush release button
F Cyclon filter + HEPA filter inside the dust tank
G Main body
H Accessories release button
I Battery status indicator
J ON/OFF Button
K Empty tank button
L Dust tank
M Lithium batteries
N Batteries release button
O Power supply
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Do not use the appliance without its filter(s)
correctly in place.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance to gather up water or
any other liquid.
- Do not use the appliance if the on/off switch
does not work.
- Remove the batteries from the appliance if you
are not going to use it for some time.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in a dry, dust-free place,
out of direct sunlight.
- Do not work on areas where there are metal
objects, such as nails and/or screws.
- Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
- Do not open the battery/ies under any circum-
stances whatsoever.
- When the battery/ies is not in use, keep it away
from other metal objects like paper clips, coins,
keys, screws ... that could connect a terminal
to another.
- Do not short-circuit the battery terminals as
this may cause an explosion or fire.
- The battery/ies should be stored at a tempera-
ture of below 40ºC.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance with pets or animals.
- Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
- Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Place the battery in the device.
CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the appli-
ance is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Be sure to place the battery correctly located
on the bottom of the handle.
- Plug the charger (O) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 4 to 5 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is rec-
ommended that the first charge of the battery
be of 6 hours in duration).
- Connect the charger to the jack using the
EN