Publicidad
Idiomas disponibles
Idiomas disponibles
10
Operating Instructions (continued)
5 .
Connect LP gas tank per "Installing LP Gas Tank" section .
6 .
Slowly turn LP gas tank valve 1 revolution to "OPEN ."
7 .
Push and turn control knob to (HIGH) . Continue to hold the control knob in to light .
8 .
After the fire pit lights, continue to hold the control knob in for 20 seconds, you will hear
clicking as you hold the knob in for 20 seconds . This heats the thermocouple, a safety
device that stops the gas flow when a fire pit is not lit and warms it up so the gas flow will
continue .
9 .
After 20 seconds, release and turn control knob counterclockwise to adjust flame to
desired height .
10 . After three attempts, if ignition does not occur, turn the burner control knob to " OFF ."
11 . Wait 5 minutes, fan with a newspaper or magazine, and repeat lighting procedure .
12 . If igniter does not light burner:
a .
Wearing heat-resistant gloves, position a lit long match or lit long butane lighter near
the igniter cover .
b .
Push and turn control knob to (HIGH) .
c .
Remove match/lighter once burner is lit .
W CAUTION: After lighting - using a fire pit tool and heat-resistant
gloves, carefully move the fire glass/lava rock back to their proper
position, being careful to avoid the flame.
13 . After lighting, observe the burner flame . Make sure all burner ports are lit and flame height
matches illustration (Figure 5) .
W CAUTION: If ignition does not occur in 5 seconds, turn control knob
to " OFF," wait 5 minutes, fan with a newspaper or magazine, and
repeat lighting procedure.
Turning Off
1 .
Turn LP gas tank valve to "CLOSED ."
2 .
Turn control knob to the " OFF" position .
Note: A "poof" sound is normal as the last of the LP gas is burned .
3 .
Disconnect LP gas tank per "Disconnecting LP Gas Tank" section .
Cleaning and Care
W CAUTION:
1. All cleaning and maintenance should be done when outdoor fire pit
is cool and with the fuel supply disconnected.
2. Do NOT clean any outdoor fire pit part in a self-cleaning oven. The
extreme heat will damage the finish.
3. Do NOT enlarge valve orifices or burner ports when cleaning the
valves or burners.
4. All components on this outdoor fire pit can become hot.
5. Do NOT clean this outdoor fire pit until all components are cool.
Notices
1.
This outdoor fire pit should be thoroughly cleaned and inspected on a regular basis.
2.
Abrasive cleaners will damage this product.
3.
NEVER use oven cleaner to clean any part of this outdoor fire pit.
Before Each Use:
1 .
Keep the outdoor fire pit area clear and free from any combustible materials, gasoline, and
other flammable vapors and liquids .
2 .
Do NOT obstruct the flow of the combustion of LP gas and the ventilation of air .
3 .
Keep the ventilation opening(s) of the LP gas tank area free and clear from debris .
4 .
Visually check the burner flames to make sure your outdoor fire pit is working properly
(Figure 5) .
5 .
See below for proper cleaning instructions .
6 .
Check all gas connections for leaks .
7 .
Check components for any signs of damage or rust .
8 .
Check for obstructions of airflow to the burner . Spiders, insects and webs can clog the
burner/venturi tube . A clogged burner/venturi tube can lead to a fire .
9 .
If damage to any component is detected, do NOT operate until repairs are completed .
Cleaning Surfaces
1 .
Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water .
2 .
For stubborn stains, use a citrus-based cleaner and a nylon scrubbing brush .
3 .
Rinse clean with water .
4 .
Allow to air dry .
Cleaning Burner
W WARNING: All cleaning should be done when appliance is cool and
with the fuel supply disconnected per "Disconnecting LP Gas Tank."
1 .
Remove the fire glass/lava rock .
2 .
Remove all dirt/dust from the burner, igniter cover and venturi area with a small brush and/
or compressed air .
LP Gas Outdoor Fire Pit
Model No. GAD15307M
1 .
Cleaning and Care (continued)
2 .
3 .
Visually inspect the burner for any rust or damage . If damage is found, replace necessary
parts with new from the manufacturer .
4 .
Clean any clogged burner ports with a stiff wire (such as an opened paper clip) .
5 .
Carefully replace the fire glass/lava rock being cautious not to block the igniter cover .
Before Storing
1 .
Turn LP gas tank valve to "CLOSED ."
2 .
Turn control knob to the " OFF" position .
Note: A "poof" sound is normal as the last of the gas is burned .
3 .
Disconnect LP gas tank per "Disconnecting LP Gas Tank" section .
4 .
Clean all surfaces .
5 .
Lightly coat the burner with cooking oil to prevent excess rusting .
W CAUTION: NEVER place cover on hot outdoor fire pit.
6 .
If storing the outdoor fire pit indoors, cover the outdoor fire pit and store in a cool dry
location away from children and pets .
7 .
If storing the outdoor fire pit outdoors, cover the outdoor fire pit with a cover for protection
from the weather .
Publicidad
