Publicidad
Idiomas disponibles
Idiomas disponibles
ENG
15. FIRST STARTING
Fill the tank up with pellet before starting the stove. Remember the feeding screw is empty and a longer time is
needed when first starting the stove. Run the relevant menu.
When first burning the stove, you can feel bad smells in the room but all the
protection greases used during production procedure are burning out. Do ventilate the
room and do not stay in till smells cannot be felt. In order to supply you with the best possible
product, al paints are water based and no harmful thinners are used.
S S WITCHIN ON
Check the cord being connect to the wall plug and for the right voltage.
Check for the main switch on the rear panel being on I position.
Check safety fuse being properly working.
Check the pellet tank being loaded with a sufficient quantity of pellet for the programmed time of heating .
Check the remote control working properly and batteries being charged.
Check day and date settings on the remote control.
Check the ashtray being properly located in the stove.
Check the fire pot grid being properly located.
Check the door being properly closed
FUEL LOADING
Cut a corner of the bag of and let pellet slowly flow into the tank. Check for any object accidentally being
packed with the pellet.
Fire alert: do absolutely not leave some pellet on the hot parts of the appliance
particularly on the top panel. When loading pellet make sure the bag doesn't touch hot
parts of the stove.
Pellet is packed in plastic or paper bags. Do carefully stock it to allow humidity from damaging it.
Check for sawdust in the pellet tank. Vacuum clean weekly.
At stove starting the loading of pellet into the fire pot takes some minutes; during this time the firing
resistance is activated. Usually combustion starts after some 5 to 6 minutes. When the smoke gas
temperature is getting the minimum temperature level the smoke probe transmits to the operating system all
the components are properly working. Now the stove switches to normal burning mode. In the contrary an
error message will be displayed on the remote control (check for error messages).
The charge of the fuel STANDARD in this modeld is made through the chute supplied as standard positioned on the
left side of the insert (can be reversed and placed on the right side). Provide in drywall or finish you are going to build
around the fireplace, a door at a suitable height for the loading of the pellets.
PELLET FIREPLACE
(Rev. 15/10/2013)
Publicidad
