Publicidad
Idiomas disponibles
Idiomas disponibles
4. FITTING THE MAIN POST.-
Follow the assembly steps in the
video:
https://youtu.be/2lu48vKTPsQ
Once the bottom post cover, is fitted,
bring the main post (25) up to boss on
the main body (99), Fig.6.
Plug connector (116), coming out of
the main post (25), into connector
(119), coming out of the boss on the
main body (99), Fig.6A.
Slip the main post (25) over the boss
(99) on the main body in the direction
of the arrow, Fig.6, making sure not to
snag any of the cables.
Fit the bolts (150) (151), along with the
washers (152) and nuts (93), Fig.6,
and tighten securely.
Lower the bottom trim section (29) for
the main post (25) down over the boss
section of the main body (99), Fig.6B.
5.- FITTING THE FOCUS BARS.-
Insert the washer(136) and the left
focus bar (8L) (marked with the letter
"L") onto the focus bar spindle (25),
Fig.7, then fit the washer(136) and the
right focus bar (8R) (marked with the
letter "R") on the other end of the
spindle. Fit the washered bolts (20)
and the flat washers (18-19) and with
the help of the box spanners tighten
securely.
Connect the terminals (118) and (117),
Fig.7A.
6.- MOUNTING THE FOOT ARMS.-
Take the left foot arm (33L) (marked
with the letter L) and insert it in the left
upper arm (8L) ensuring that the letters
coincide (L), Fig.8 insert screws (22)
and the flat washers (19-21) and tighten.
Follow the same procedure for the
right foot arm (33R).
7.- FITTING THE FEET.-
Take the right pedal (42R), Fig.9,
(marked with the setter "R") and slide
it onto the crank shaft (81R) on the
right- hand side of the machine.
Now take washers (32) and (39) and
bolt (20) and tighten securely.
Finally, fit the caps (38).
Take the left pedal (42L), Fig.9,
(marked with the setter "L") and slide it
onto the shaft (70L) on the left-hand
side of the machine.
Now take washer (19) and (39) and
bolt (20) and tighten securely.
Finally, fit the caps (38).
Take the right foot (42R) and position
it in the "U" of the lower right arm (8R)
Fig.9, insert screw (34) as shown in
Fig 9 and take flat washer (32) and
self-locking nut (31) and tighten firmly.
Take the left foot (42L), and position it
in the "U" of the lower left arm (8L)
Fig.9, insert screw (34) as shown in
Fig.9 and take flat washer (32) and
self-locking nut (31) and tighten firmly.
8.- FITTING THE FOCUS BAR
SIDE COVERS.-
Take the covers (15R), marked on the
inside with the letter "R", and position
them at the spindle end with the bars
on the right hand side, as shown in
Fig.10B. Now use screws and (27) to
attach them.
16
Publicidad
