Publicidad
Idiomas disponibles
Idiomas disponibles
5.
To place the new belt begin by routing the belt around the
two outer spindle pulleys, then around the front spindle
pulley as shown in Fig. 7-9.
Front Spindle
Deck Idler
Pulleys
Outer Spindle
6.
Route the belt around the two deck idler pulleys as shown
in Fig. 7-9.
7.
Reinstall the belt keeper rod loosened earlier.
CAUTION:
may result in serious damage to your tractor's PTO
system.Remount the belt guards removed earlier.
8.
Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
28
S
7— S
ection
ervice
Pulley
Pulleys
Figure 7-9
Failure to reinstall the belt keeper rod
9.
Pull the right side of the belt and place the narrow V side of
the belt into the PTO pulley. See Fig. 7-10.
Figure 7-10
10.
While holding the belt and pulley together, rotate the
pulley to the left (See Fig. 7-10). Continue holding and
rotating the pulley and belt until the belt is fully rolled into
the PTO pulley.
PTO Belt
Rotate
Pulley
Publicidad
