Operation - Klarstein Bornholm Curved Ambient Manual De Instrucciones De Mantenimiento Para El Usuario

OPERATION

Starting
1. Take out the heater from the carton carefully. Please save the carton for off-season storage.
2. Make sure the power switch is in the OFF position before plugging it in.
3. Ensure the heater is fully assembled according to the Mounting Guide .
4. It is better not to use the same electric outlet with other high wattage electrical appliances in order to
avoid overloading your circuit.
Turn on
Plug in the unit and turn on its power switch, it is in standby mode and shows current time, with button light
(13) and (14) / (15) and (16) on. But then button light (14) and (15) / (16) will disappear after 10s.
Time setting
Press buttons of setting (16) and (15) together for 3s, week indicator flashes and time setting is activated.
Select a day by (14) or (15); press (16) then Hour Indicator (5) flashes, again by (14) or (15) buttons to set Hour.
Again press (16) for minute setting ( minute indicator (7) flashes ). set the desired minute by buttons (14) or
(15), after that press button (16) and save all setting .
Temperature setting
Press button (16). Temp indicator (17) flashes and its setting is activated.
Press (14) or (15) to set the temperature and (16) to save it, or just leave it 5s, setting is saved automatically.
Select heating level
(14) button runs low heat setting ( indicator
on), or through shifting button ( on the remote control to choose high or low heat.
Child-lock setting
Press both (14) and (15) for 3s, child lock indicator "[]" is on, system is locked and no setting could be done.
After 2 s, display shows again area temperature. In this mode, it only shows child lock indicator when any
button is pressed.
Methods to unlock: Press both (14) and (15) for 3s, the unit is unlocked and any setting could be done again.
Display buttons activation
Normally display buttons light are off when unit is working, touch the panel area below temperature, they
are on again.
23
light on),  button runs high heat setting (indicator light