Features; Unpacking And Assembly; Unpacking - Surtek HL730 Manual De Usuario

7. NEVER supply any liquid other than water to
the water inlet.
8. NEVER use the chemical injection facility to
introduce solvents, e.g. paint thinners, petrol,
oil etc.
9. ALWAYS release any residual pressure in the
system by turning off the water supply and op-
erating the trigger before disconnecting any
hose or accessory.
10. ALWAYS keep the machine itself dry and
well clear of water spray
11. ALWAYS wear protective clothing and safe-
ty glasses. Loose particles and other debris may
be propelled at high speed by the water jet.
12. ALWAYS grip the gun firmly before press-
ing the trigger, expect the gun to 'kick' when
starting.
13. ALWAYS respect the requirements of the
local water company. Power washers may only
be connected to the mains drinking water sup-
ply, if a backflow preventer valve is installed in
the supply hose.
14.When not in use, ALWAYS disconnect from
the water supply, and ensure the system is com-
pletely drained. Store in a cool dry location.
15. When using the chemical injection facility,
use only the chemical cleaning agents (deter-
gents), that are approved for power washers
or recommended by the dealer

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
7
6
5
1. GUN.
2. NOZZLE.
3. MOTOR.
4. WHEEL.
5. PUMP.
6. FRAME.
7. LANCE.

UNPACKING AND ASSEMBLY

UNPACKING

Unpack your power washer and check to en-
sure the following items are present.
Contact your seller immediately if any parts are
missing or damaged.
• Hose, Gun/lance, Spray wand, Hook, Nozzle,
Detergent hose with filter, Oil plug, Rubber
feet, Fixings pack.
ASSEMBLY
CONNECTING THE WHEELS
1. Remove the nut, spring washer and washer
from the axle.
2. Fit the axles into the
axle ports as shown,
secure with the nut,
spring
washer (Fig. 1).
3. Fit the wheels to the axles and secure with
the nut and washer.
RUBBER FEET
1. Fit the rubber feet
to the legs as shown
in figure 2.
ASSEMBLE THE LANCE
1
1. Connect the spray
wand to the lance and
tighten securely (Fig.3).
THE HIGH PRESSURE HOSE
CONNECT THE HOSE
TO THE GUN
2
1. Slide the connector
on the hose back-
wards (Fig.4-1).
2. Push the gun into
3
the connector.
3. Release the connector.
NOTE: Mak e sure the connection is secure.
4
E N G L I S H •
washer and
Fig.1
Fig.2
Fig.4
U se r ' s m an ua l
Fig.3
15