Preparations At The Workplace - Hilti TE 50 Manual De Instrucciones Original

5 Operation

5.1 Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool
or before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely.
Check that the clamping band is engaged in the groove provided on
the tool.
1. Slide the side handle clamping band over the chuck from the front and
into the recess provided.
2. Bring the side handle into the desired position.
3. Secure the side handle by turning the knob until the clamping band is
tight.
5.3 Fitting / removing the accessory tool
WARNING
Risk of injury! The accessory tool becomes hot in use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
◁ The product is ready for use.
3. Pull the chuck back as far as it will go and remove the accessory tool.
Note
Use only the recommended grease supplied by Hilti. Use of unsuit-
able grease may cause damage to the product.
8 English
Printed: 08.03.2017 | Doc-Nr: PUB / 5070997 / 000 / 03
2
4