Publicidad
Idiomas disponibles
Idiomas disponibles
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by
carpets, rugs etc.
• Before placing it on small tiles, apply a rubber coating.
• Never try to correct any unevenness in the floor by putting pieces of
wood, cardboard or similar materials under the machine.
• If it is impossible to avoid positioning the machine next to a gas
cooker or coal-burning stove, an insulating panel (85x57 cm) covered
with aluminium foil on the side facing the cooker or stove, must be
inserted between the two appliances;
• The machine must not be installed in rooms where the temperature
can drop below 0.
• The water inlet hose and the drain hose must not be kinked.
• Please ensure that when the appliance is installed, it is easily accessi-
ble for the engineer in the event of a breakdown.
Levelling
Carefully level by screwing the adjustable feet in or out. Never place
cardboard, wood or similar materials under
the machine to compensate for any
unevenness in the floor.
Water inlet
Connect the water inlet hose to a separate
tap with a 3/4" thread.
The other end of the inlet hose which con-
nects to the machine can be turned in any direction. Simply loosen the
fitting, rotate the
hose and retight-
en the fitting,
making sure there
are
no
leaks.
The inlet hose
must
not
lengthened. If it
is too short and you do not wish to move the tap, you will have to pur-
chase a new, longer hose specially designed for this type of use.
water
be
Installation
75
Publicidad
