Orbegozo CTP 1200 Manual De Instrucciones página 8

CTP 1200
3. Slide the comb depending on the length of cut you want.
5. To remove the blade, press down on the blade in the opposite direction
to switch the device. See the figure below.
CUTTING WITHOUT ACCESSORIES
Cut the hair placing the hair trimmer's head directly on the scalp. Cutting without accessories will leave the
hair length at one millimeter or less.
HOW TO CHARGE THE DEVICE
1. Place the switch on the main unit in position "OFF".
2. Plug it in.
3. The lighted indicator will turn red when it is plugged in.
4. The battery will be completely charged after 8 hours of charging.
5. Once the battery is charged, unplug the main unit.
6. Place the switch in position "ON" to use the device.
7. Place the switch in position "OFF" after cutting your hair.
DURATION OF THE BLADE AND THE BATTERY
The blade's lifetime will vary according to the frequency and length of use. The blade's life expectancy is
about 6 years if the hair trimmer is used twice a month for 20 minutes each time. If the efficiency of the cut
is substantially reduced despite appropriate maintenance, this means that the blades have exceeded their
useful life and need to be changed.
The battery's life expectancy will vary according to the frequency and length of use. If the battery is charged
3 times a month, its useful life will be approximately 6 years. If the unit is not charged for more than six
months, the battery will lose charge and its useful life may be reduced.
Therefore, it is recommended to recharge the unit at least every six months, even if it is not used regularly.
BLADE CARE
Please clean the blade after use to protect it appropriately.
1. Place the switch in position "OFF" and unplug it.
2. Remove the blade.
3. Take the blade from the hair trimmer and remove the upper part of the blade from the set.
4. Please be careful with the blade since it may cut you.
5. Use the cleaning brush to clean the blade and the unit.
6. Place the blade in the unit.
4. To replace the blade, place it in the hole in the bottom and then press
until you hear "click".
8