Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking Your Refrigerator
WARNING
Use two or more people to move and
install the refrigerator. Failure to do so
can result in back or other injury.
Your refrigerator is heavy. When moving
the refrigerator for cleaning or service,
be sure to protect the
the refrigerator straight out when mov-
ing it. Do not wiggle or walk the refrig-
erator when trying to move it, as
damage could occur.
Keep
materials and va-
pors, such as gasoline, away from the
refrigerator. Failure to do so can result
explosion, or death.
Remove tape and any temporary labels from
your refrigerator before using. Do not remove
any warning-type labels, the model and serial
number label
To remove any remaining tape or glue, rub
the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing
a small amount of liquid dish soap over the
adhesive with y
water and dry.
Please remove vinyl from doors before
connecting unit to the electrical supply
(on some models).
Do not use sharp instruments, rubbing alcohol,
move tape or glue. These products can damage
the surface of your refrigerator.
Refrigerator shelves are installed in the ship-
ping position. Please reinstall shelves according
to your individual storage needs.
r. Always pull
Wipe with warm
ve cleaners to re-
Choosing the Proper Location
Select a place where a water supply can
be easily connected for the automatic
icemaker.
NOTE
The water pressure must be between 20
and 120 psi (138 and 827 kPa) on models
without a water ter and between 40 and
120 psi (276 and 827 kPa) on models with a
water lter.
The refrigerator should always be plugged
into its own individual properly grounded
electrical outlet.
This provides the best performance and
also prevents overloading house wiring
from overheated wires. It is recommended
that a separate circuit serving only this
appliance be provided.
WARNING
To reduce the risk of electric shock, do not
install the refrigerator in a wet or damp area.
Flooring
To avoid noise and vibration, the unit must be
leveled and installed on a solidly constructed
r. If required, adjust the leveling legs to
compensate for unev
front should be slightly higher than the rear to
aid in door closing. Leveling legs can be turned
easily by tipping the cabinet slightly. Turn the
leveling legs to the left to raise the unit or to
the right to lower it. (See Leveling and Door
Alignment.)
NOTE
Installing on carpeting, soft tile surfaces, a
platform or weakly supported structure is
not recommended.
INSTALLATION
11
r. The
Publicidad
