Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION:
1. If
is appeared during power-on process, that means this wrench has ever been
applied more than 110% of torque of the spec.
2. IMPORTANT!
When using the wrench in "ANGLE" mode the wrench must be placed flat (horizontally) on
table or workbench before any attempt is made to change values or to power up the unit. If
the user attempts these functions without following the instructions above the unit's display
will begin to flash a series of four zeros in the top half of the screen.In order to re-start the
unit; press
.
ZERO RESET
- If necessary, Zero-reset will guarantees an accurate measurement.
- After power on,
- Usually press
- In angle mode, please keep the wrench steady without any disturbance and pres
zero-reset.
- In torque mode, if an external force is applied to the torque wrench during zero-reset period,
an initial torque offset error will occur.
AUTO POWER OFF
The wrench will auto power off after about 2 minutes idle for power saving. Press
on the wrench again.
CAUTIONS:
During communication period (
RESET THE WRENCH
- To reset the wrench, loosen the battery cap then tight it to re-start. After reset, remember to
press
.
- If the wrench does not function normally or
process to reset the wrench.
LOW VOLTAGE INDICATOR
If the battery serial voltage is in low voltage status, the wrench will display a battery symbol and
then turn off . Replace batteries.
button is for zero reset.
to zero reset the digital torque-angle wrench before using the wrench.
appears) the auto power-off function is disabled.
appeares, please go through the reset
s
to do
to power
27
Publicidad
