Publicidad
Idiomas disponibles
Idiomas disponibles
To ensure that this jack maintains its operating
efficiency, the following maintenance schedule
and procedures are required. These schedules
and procedures are the responsibility of the jack
owner.
REGULARLY
- Usage and shop conditions
determine frequency.
1. Always store the jack in a well protected area
where it will not be exposed to inclement
weather, corrosive vapors, abrasive dust, or
any harmful elements. The jack must be
cleaned of water, snow, sand, grit, oil,
grease
or
immediately after exposure.
2. Every jack owner is responsible for keeping
jack labels clean and readable. Cleaning can
be accomplished by using a mild soap solution
to wash external surfaces but not any moving
hydraulic components. Immediately after
cleaning dry the jack completely.
3. Inspect the jack before each work day. Do not
use the jack if any component is cracked,
broken, bent, shows sign of damage or leaks
hydraulic fluid. Remove from service until
properly serviced or repaired.
4. Inspect the jack before each day for loose or
missing hardware or components. Take
corrective action before using. Premature
wearing or damage to any jack components
resulting from loose or missing hardware are
not eligible for warranty consideration.
WEEKLY
1. The jack must be lubricated with lithium base
grease (only) in order to prevent premature
FJ300
MAINTENANCE
other
foreign
wearing
operation. A general purpose lithium base grease
must be used in the grease fittings provided in
both front wheels FJ300-4, lift arm assembly,
and two in the handle yoke assembly FJ300-11.
Additional areas of lubrication are found in
Figure 1. Worn parts resulting from the use of
improper grease, inadequate or no lubrication are
not eligible for warranty consideration.
matter
#2
#1
Figure 1
a. Using a grease gun, add lithium base
grease to grease fitting in the lift arm pivot
shaft, front wheels, and handle yoke.
b. Lubricate all linkages and pivot points.
(Use white lithium spray grease only.)
c. Remove
receptacle and handle end. (Use white
lithium spray grease only.)
d. Lubricate both rear casters bearings (Use
white lithium spray grease only.)
8
of
parts
and
guarantee
#1
handle;
lubricate
smooth
#3
#1
#4
#3
#2
handle
Rev. 07/23/18
Publicidad
