Publicidad
Idiomas disponibles
Idiomas disponibles
Due to the presence of hazardous
components in the equipment, used
electrical and electronic equipment may
have a negative impact on the
environment and human health.
Do not dispose of electrical and
electronic appliances with household
waste!
In accordance with the European
Directive on waste electrical and
electronic equipment and its adaptation
to national law, used electrical and
electronic equipment should be collected
separately and delivered to a separate
collection point for municipal waste,
operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Intended use
The tool is intended for collecting both wet and dry dust.
The tool is suitable for commercial use, for example in
hotels, schools, hospitals, factories, shops, offices and
rental businesses.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. This tool
should be grounded while in use to protect the operator
from electric shock. Use only three-wire extension cords
which have three-prong grounding-type plugs and
three-pole receptacles which accept the tool's plug.
VACUUM CLEANER SAFETY
WARNINGS
WARNING: IMPORTANT! READ CAREFULLY all
safety warnings and all instructions BEFORE USE.
Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
1. Before use, make sure that this cleaner must be
used by people who have been adequately
instructed on the use of this cleaner.
2. Before use, operators shall be provided with
information, instruction and training for the use of
the machine and the substances for which it is to
be used, including the safe method of removal and
disposal of the material collected.
3. Only use the socket outlet on the cleaner for
purposes specified in the instructions.
4. If foam/liquid comes out, switch off immediately.
5. Clean the water level limiting device regularly and
examine it for signs of damage.
6. Do not use the cleaner without the filter. Replace a
damaged filter immediately.
7. USE OF EXTENSION CORD. When using an
extension cord because of the great distance to
your power source, try to employ a cord that is
sufficiently thick but not too long, or cleaner
performance will be adversely affected. For
outdoor applications use an extension cord
suitable for outdoor use.
8
8. VOLTAGE WARNING: Before connecting the
cleaner to a power source (receptacle, outlet, etc.)
be sure the voltage supplied is the same as that
specified on the nameplate of the cleaner. A power
source with voltage greater than that specified for
the cleaner can result in SERIOUS INJURY to the
operator as well as damage to the cleaner. If in
doubt, DO NOT PLUG IN THE CLEANER. Using a
power source with voltage less than the
nameplate rating is harmful to the motor.
9. AVOID UNINTENTIONAL STARTING. Be sure
switch is OFF when plugging in.
10. Do not attempt to pick up flammable materials, fire
works, lighted cigarettes, hot ashes, hot metal
chips, sharp materials such as razors, needles,
broken glass or the like.
11. NEVER USE THE CLEANER IN THE VICINITY OF
GASOLINE, GAS, PAINT, ADHESIVES OR OTHER
HIGHLY EXPLOSIVE SUBSTANCES. The switch
emits sparks when turned ON and OFF. And so
does the motor commutator during operation. A
ENE084-1
dangerous explosion may result.
12. Never vacuum up toxic, carcinogenic,
combustible or other hazardous materials such as
asbestos, arsenic, barium, beryllium, lead,
pesticides, or other health endangering materials.
ENF001-1
13. Always place the cleaner on a horizontal flat
surface to prevent it from falling or moving
unintentionally.
14. Never use the cleaner outdoors in the rain.
15. For Finland, this machine is not to be used
outdoors at low temperature.
16. Do not use close to heat sources (stoves, etc.).
17. If the exhaust air is returned to the room, it is
necessary to provide for an adequate air change
rate in the room. Reference to National regulations
is necessary.
ENB119-6
18. GUARD AGAINST ELECTRIC SHOCK. Prevent
body contact with grounded surfaces. For
example; pipes, radiators, ranges, refrigerator
enclosures.
19. Do not block cooling vents. These vents permit
cooling of the motor. Blockage should be carefully
avoided otherwise the motor will burn out from
lack of ventilation.
20. Keep proper footing and balance at all times.
21. DO NOT ABUSE CORD. Never carry the cleaner by
cord or yank it to disconnect from receptacle.
Keep cord away from heat, oil, and sharp edges.
Inspect cleaner cords periodically and if damaged,
have repaired by authorized service facility.
Inspect extension cords periodically and replace if
damaged.
22. Do not fold, tug or step on the hose.
23. Stop the cleaner immediately if you notice poor
performance or anything abnormal during
operation.
24. DISCONNECT THE CLEANER. When not in use,
before servicing, and when changing accessories.
25. Clean and service the cleaner immediately after
each use to keep it in tiptop operating condition.
26. MAINTAIN THE CLEANER WITH CARE. Keep the
cleaner clean for better and safer performance.
Follow instructions for changing accessories.
Publicidad
