Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
WARNING: To reduce the risk of fire or explosion, do not operate this vacuum in areas with flammable gases, vapors or explosive
dust in the air. Flammable gases or vapors include but are not limited to: lighter fluid, solvent-type cleaners, oil-based paints, gasoline,
alcohol or aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not use this vacuum as a sprayer for any flammable or
combustible liquid. To reduce the risk of health hazards from vapors or dusts, do not vacuum toxic materials.
WARNING: The operation of any utility vacuum can result in foreign objects being blown into the eyes, which can result in severe eye
damage. Always wear safety eyewear complying with ANSI Z87.1 (or in Canada, CSA Z94.3) before starting operation.
CAUTION: To reduce risk of hearing damage, wear ear protectors when using the vacuum for extended hours or when using it in a
noisy area. This 15.1 Liter / 4 Gal wet/dry vacuum is assembled at the factory and ready for use when you remove it from the carton.
The unit is ready for dry vacuuming or blowing. After you plug the power cord into the wall receptacle, turn the unit "ON" by pushing the
switch from position "O" to position "I" as shown in Figure A. The "O" is the "OFF" position and the "I" is the "ON" position.
INSTALLING CASTERS
□
Insert the casters (I) into the bottom of the caster base as shown in Figure B.
□
Strong pressure is required. Listen for the click to ensure they are locked in place.
O = OFF
I = ON
Figure A
I
Figure B
5
l P
a e
e s
o c
H
t n
c a
1 t
8 -
8 8
H -
D
H -
U
S
KY for further assistance.
U
S
Y K
O T
O
S L
C .
O
M
Publicidad
