IPC I1813P T Manual De Instrucciones página 15

The electrical system to which the ap-
pliance is connected must be realized in
compliance with the laws of the country
of installation.
Whenever extension cables are
used, the relative plugs and so-
ckets must at least comply with
protection class IPX5 (i.e. protection
against water jets). Use of inappropriate
or non-compliant extension cables may
incur in danger and hazards to the devi-
ce. The H.P. cleaner must be connected
to the electric supply by means of an
omnipolar switch with opening contacts
of at least 3 mm. This switch must have
electric features which are consistent with
the appliance.
The presence of a differential magneto-
thermal switch is necessary with a sen-
sitivity of equivalent to 30 mA, above the
power socket or the system.
The appliance is disconnected from the
electric supply only by pulling out the plug
or switching off the omnipolar switch.
Water cleaners with the "Total
Stop" device should be considered
as off when the omnipolar switch is
in the "O" position or the plug is unplugged
from the socket.
Please beware that when the Total Stop
system is active the device may look as
though it has been powered off, however,
the machine is not totally powered off until
the mains switch has been turned to off
and/or the mains power plug has been
detached.
Only put the appliance into operation
providing that all components are free of
defects.
Firstly check the mains attachment wire,
the high pressure pipe, the spraying devi-
ce and the body. Do not tread on the high
pressure pipe; do not pull, bend or twist
it. Do not shift the appliance by pulling it
by the high pressure pipe. Never operate
with a defective high pressure pipe, but
always replace with original spare. The
high pressure pipe must be homologated
for the permitted working overpressure of
the appliance.
The functional overpressure and maxi-
mum temperature admitted, as well as
the date of construction are printed on the
high pressure pipe covering.
WARNING: This machine was designed
to be used with the detergent recommen-
ded by the manufacturer. The use of other
detergents or chemical products may
compromise the safety of this machine.
Use only slightly alkaline detergents (Ph
9.1, 1% solution), that are over 90% bio-
degradable.
As concerns water connection, refer to
the regulations of the individual countries.
The constructor will not accept liability for
any damage to people, animals or things
as the result of improper, incorrect or
unreasonable use, or use which does not
comply with the above indications.
This device is not intended for use by
physically, sensorially or psychological-
ly impaired and/or disabled individuals
(including all children). It is also not in-
tended for use by individuals without any
knowledge, experience or operation skills
on the device, unless said individuals
haven't first been monitored by a person
put in charge of their safety and/or have
been regularly instructed on how to use
the device correctly. Children must be
carefully monitored to ensure they do not
play with the device.
Water that flows through a system
backflow preventer cannot be classified
as potable water. Use a suitable potable
water backflow preventer device, com-
pliant to the EN 12729 type BA standard
provisions.
Use only flexible hosing, accessories
and fittings recommended by the manu-
facturer.
Do not use the appliance in the event of
any damage to the power cable or other
parts such as piping and fitting.Use only
original spares.
Undertake only the maintenance opera-
tions described in the user instructions.
Contact the Technical Assistance service
for all other interventions.
At least once a year, have the safety of the
water cleaner checked by our technical
service centre.
The machine must be handled and/or
moved ONLY with the appropriate handle
(do not attempt to move the machine by
tugging on the tube and/or on the power
supply cable);
Before operating the machine, ensure that
it is standing very firmly on a flat, smooth
and horizontal surface.
In case of damage or malfunction, switch
off the appliance (disconnecting it from
the water main and from the electricity
main via the omnipolar switch or by
unplugging the plug in the case of water
15