Philips SQM5232S Manual De Instrucciones página 6

  U singtheenclosedmountingtemplate,
2
place the diagram against the wall and mark
six locations on the wall where the mount
Is to be Installed.
With the help of another person, place the
3
mount against the wall and level it using the
bubble guide.
While another person holds the mount in
4
place, mark six locations on the wall where
the mount is to be installed.
  S etthemountasideanddrilla7/16"(11mm)
5
pilot hole at each marked location. Remove
any excess dust from the holes.
  I nsertaconcreteanchor(P)intoeachhole
6
so that it is flush with the concrete surface.
A hammer can be used to lightly tap the
anchors into place if necessary.
  P lacethemountbackagainstthewalland
7
secureitusingthelagbolts(Q)andlagbolt
washers(R)provided.Donotover-tighten
these bolts and do not release the mount
until all bolts are in place.
  O nceall(6)lagboltsareinplaceyoumust
8
tighten each one. Be sure not to over
tighten.
Note
D
If the concrete wall is covered by a layer
of plaster or drywall, the concrete anchor
must pass completely through the layer to
rest flush with the concrete surface.
6
All manuals and user guides at all-guides.com
2
2
3.3 Attaching the arms to the display
Warning
B
Use extra care during this part of the
installation. Avoid laying your display face
down if possible as it may damage the
viewing surface.
  E xaminethebackofyourtelevision.
1
If the back of your display is flat: You
will be using one of the shorter bolts from
the hardware kit.
If the back of your display is curved
or recessed: You will be using one of the
longer bolts and a spacer.
Determine the correct diameter bolt
2
to use by trying one bolt each from Bags
1-4ofthehardwarekit.Donotforceany
of the bolts – if you feel resistance stop
immediately to avoid damaging your display.
3
4
3
4