Beamz LCB366 Manual Del Usuario página 5

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
The unit may be set up on a stable and even surface. By means of various mounting options, the device can also be mounted on a truss, see picture below.
For fixing, certified clamps with correct save working load are required. The mounting place must be of sufficient stability and be able to support a weight
of 10 times of the unit's weight. Secure the unit with a safety cable so that it cannot fall down.
In the image below, there are two ways to mount the device on a truss. We advise you to choose 'centre load', this keeps the weight load in balance for
your truss construction. This 'front load' is not possible when the truss is assembled in a ground support.
When carrying out any installation, always comply European and national guidelines concerning rigging, truss and all other safety issues. Always let the
installation checked out by an authorized dealer!