Before Using Your Appliance
• Remove the exterior and interior packaging.
• Check to be sure you have all the following parts:
1
(3) Three Freezer Door Bins
2
(3) Three Freezer Shelves
3
(2) Two Freezer Drawers with Glass Cover
• Before connecting the unit to the power source, let it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system due to handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Appliance
• Place your refrigerator-freezer on a floor that is strong enough to support the refrigerator- freezer when
it is fully loaded. To level your refrigerator-freezer, adjust the leveling legs at the bottom of unit.
• ALLOW 3-5 INCHES OF SPACE BETWEEN THE BACK OF THE APPLIANCE AND THE
WALL AS WELL AS A MINIMUM OF ½" (HALF INCH) AT EACH SIDE OF THE UNIT AND ONE
(1) INCH AT THE TOP, WHICH ALLOWS PROPER AIR CIRCULATION TO COOL THE
COMPRESSOR AND CONDENSER.
Minimum Space Allowances
Top
Sides
Back
• Locate the unit away from direct sunlight and heat sources (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase power consumption. Extreme cold room temperatures
may also cause the refrigerator- freezer to not perform properly.
• Avoid placing the unit in a moist area.
• Plug the unit into an exclusive, properly-installed grounded wall outlet. Do not under any circumstances cut or
remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should
be directed to a certified electrician or an authorized FORNO Products service centre.
INSTALLATION INSTRUCTIONS
One (1) inch
Half (½) inch on each side
Three to Five (3 - 5) inches at the back
4
(3) Three Refrigerator Shelves
5
(2) Two Vegetable Crispers with Glass Cover
6
(3) Three Refrigerator Door Bins
8