Publicidad
Idiomas disponibles
Idiomas disponibles
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
Action
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Saw blade Assembly and
Removing
WARNING: Always
remove the battery
before changing the blade!
Safety On/Off Switch
WARNING:To avoid
cutting injury from the
sharp blade, please don't put
your hands around the Base
Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Cross and Rip Cutting
NOTE: To avoid injury from
Kickback, please don't start
cutting until the blade runs
stably.
Cutting Depth Adjusting
Parallel Guide
Pocket Cutting
Sawdust Removal
Lithium-Ion Cordless Circular Saw
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition and
the tooth count of the saw blade. Therefore, use only
sharp saw blades that are suited for the material being
cut.
Choice of blades: 24 teeth for general work, approx. 40
teeth for finer cuts, more than 40 teeth for very fine cuts
into delicate surfaces, diamond for tile, cement board,
etc.
Only use saw blades recommended.
Figure
MAINTENANCE
See Fig. A1
Remove the battery pack from the tool before
See Fig. A2, A3
carrying out any adjustment, servicing or
maintenance.
See Fig. A4
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional lubrication
See Fig. B
or maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
See Fig. C1, C2
persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base to
ensure proper performance.
For Battery tools
The ambient temperature range for the use and storage
of tool and battery is 0
See Fig. D1, D2
The recommended ambient temperature range for the
charging system during charging is 0
See Fig. E1, E2
ENVIRONMENTAL
See Fig. F
PROTECTION
See Fig. G1, G2
See Fig. H
retailer for recycling advice.
C-45
C.
o
o
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
15
C-40
C.
o
o
EN
Publicidad
