Schneider Airsystems BAM 250-10-50 W Manual De Instrucciones Original página 35

Problem
D The compressor
starts up briefly
when the switch-on
pressure is reached
or hums,
switches off auto-
matically.
E Compressor
continuously.
F During operation,
compressed
escapes via
load-relieving valve.
G After the switch-off
pressure is reached,
compressed
escapes via
load-relieving valve
until switch-on
pressure is reached
H Compressor
switches on
quently.
I Safety valve blows
out.
J Compressor over-
heats.
K Oil-lubricated com-
pressor: the
level rises without
oil having
added.
Cause
Mains connection cable longer
than permitted or the cross
section is too small.
then
runs Intake filter badly contami-
nated.
Air consumption of compressed
air tools is too high.
Leakage at compressor.
Excessive condensate in the
vessel.
Compressed air line leaky:
Condensate drain valve is open
or missing.
Load-relieving valve leaky.
air
the
Check valve insert leaky or
defective.
air
Check valve is damaged.
the
Excessive condensate in the
fre- pressure vessel.
Compressor overloaded.
Vessel pressure is higher than
the set switch-off pressure.
Safety valve is defective.
Air supply not sufficient.
Cooling fins on cylinder (cylin-
der head) contaminated.
Duty cycle too long.
Condensate collects in the oil.
oil
High humidity.
been
BAM/CPM/SUM/UNM/ZPM
Remedy
Check connection cable length
and cable cross-section
Chap. 2.4.4)
Clean or replace intake filter.
Check the air consumption of the
tools. Contact the service partner
Locate leak, contact service part-
ner.
Drain the condensate
Chap. 2.6.5).
Check compressed air line, plug
leak.
Close or replace.
Clean or replace load-relieving
valve.
Clean or replace the check valve
insert (see Chap. 2.6.11).
Replace check valve.
Drain the condensate
Chap. 2.6.5).
See item E
Have the pressure switch reset/
replaced by a qualified person.
Replace safety valve or contact
service partner.
Ensure sufficient ventilation.
Clean cooling fins on cylinder
(cylinder head).
Switch off compressor.
Compressor is too large, contact
service partner.
Change oil.
GB
(see
(see
(see
II/15