Dirt Devil Power MAX UD70164 Manual Del Usuario página 17

REPLACE THE BELT
1. Turn your vacuum over.
Use a Phillips screwdriver to
take off the 6 screws.
Remove the bottom plate.
3. Slip belt around the brushroll
in area without bristles (A)
and metal pin (B). Each end of the
brushroll will fit into pockets on
each side of the nozzle (C). Put the
plate back on and screw together.
NOTE: Any other servicing should be done by an authorized service representative. If appliance
is not working as it should, has been dropped, damaged, left outdoors or dropped into water,
take it to a service center prior to continuing use.
For replacement belt style 5 visit dirtdevil.com or call us at (800) 321-1134.
CAUTION
To reduce the risk of injury from moving parts - Unplug
before servicing.
2. Then take off that old belt.
Slide on a new belt with the
lettering on the outside.
LUBRICATION:
The motor and brushroll are
equipped with bearings which
contain sufficient lubrication for
their lifetime. The addition of
lubricant could cause damage.
Do not add lubricant to motor
or brushroll.
A
B
C
7 1 7