Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
CAUTION:
the protective material, as it may damage the product. Be careful not to throw away small parts
such as bolts, washers, etc. that may be wrapped in the protective materials.
Step 1: Place lower cross leg (C) on
ground, line up notches and place upper
cross leg (D) over lower cross leg (C).
WARNING:
section of base with sand. Add WATER to wet the sand and continue to fill each section with
water up to top. Cover hole with cap. It is recommended at least 91 kg (200 lbs) of weight be
placed on cross legs to ensure stability. Failure to do so will result in a weight imbalance and
cause umbrella to tip, causing damage and/or personal injury.
A
Step 3: Fill each base (A & B) with sand, cover with cap (M). Place pole support cup (L)
onto holder pole (F) and lay on top of blow molded base (B).
Do not use sharp tools or equipment such as a knife or scissors when removing
D
C
Before opening umbrella, complete assembly as instructed in manual. Fill each
F
M
HH
Step 2: Attach holder pole (F) to base by
using bolts (GG) and washers (HH) (found
in blister pack). Be careful not to over
tighten. Adjust holder pole (F) to be sure
it is positioned correctly on base. Finally,
tighten with adjustabe wrench or open-
end wrench (not included).
L
B
4
F
GG
D
C
Sand (4 bags)
22.75 kg
22.75 kg
50lbs
50lbs
22.75 kg
22.75 kg
50lbs
50lbs
91 kg / 200 lbs
E
Publicidad
