BRIGHT Coop BD3 7570 Manual Del Operador página 23

Drivers operating instructions
1. Wear clothes suited for driving the lift truck. Avoid loose fitting clothes.
2. Never operate the vehicle when hands or feet are wet or soiled with greasy substances.
3. When mounting the forklift, do not use the steering wheel as a pull handle; use the step provided when mount-
ing or dismounting the forklift.
4. For increased comfort adjust the driver's seat as required.
5. The operator must always be seated normally when in the driver's seat. It is prohibited to have arms, legs or
any part of the body, extended from the cab of the forklift.
6. Always remember to fasten your seat belt and adjust it properly before operating the forklift.
7. Never allow a passenger to travel on the lift truck, or in the cab.
Before starting the forklift
1. Check the condition of the tires and tire pressures.
2. Check all fluid levels engine oil, hydraulic reservoir oil, and cooling system.
3. Check for possible leaks: oil, fuel, or other fluids.
4. Check the latches on the hood and engine compartments.
5. It is advised that the operator be familiarized with the location and operation of all the instruments and controls
before operating the forklift.
Starting the forklift
1. Verify that the parking brake is engaged.
2. Make sure that the Hydrostatic direction & speed control pedal is in neutral position.
3. In cold condition turn the ignition key to position "ON" and hold until indicator light turns off.
4. Turn the key to the "ST" (Starting) position and the engine should start. Release the key immediately when the
engine starts.
5. Check to see that the oil pressure lamp and charge lamp are off. If the lamps are still on, immediately stop the
engine, and determine the cause.
6. Warm up the engine at medium speed without load.
Bright Forklift
BD3–7570
GENERAL OPERATION INSTRUCTIONS
Do not operate the forklift unless properly seated, with
Never try to start the forklift by pushing or towing
it. Pushing or towing the forklift can cause severe
Do not engage the starter motor for more than 15 seconds
at a time. Wait 2 minutes between starting attempts,
allowing starter to cool down. Engage the pre-heater for
General Operation Instructions
seat belt fastened
damage to the transmission
10 seconds between attempts.
23