Publicidad
Idiomas disponibles
Idiomas disponibles
Verifying system components
DR6300 system components
•
System bezel (optional)
•
Power cables (optional)
•
Power cable retention straps (2)
•
Pair of mounting rails (optional)
•
Cable management arm (optional)
•
System documentation
Pre-installation requirements
Network
•
An active network with available Ethernet cables and connections.
•
If your system has a 1 GbE NIC, connect all NIC ports on the NIC daughter card. If your system has a 10 GbE
NIC, connect the 10 GbE ports on the NIC daughter card.
•
If your system has both 10 GbE and 1 GbE NIC's then by default the 1 GbE NIC will be disabled. If you want to
modify the default setting, see the DR Series System Command Line Reference Guide.
NOTE:
Quest recommends to use CAT6a copper cables with a 10 GbE NIC. If you have an enhanced small
form factor pluggable (SFP+) NIC, you must use a Quest-supported SFP+ LC fiber optic transceivers or
twin-axial cabling. For more information on network cabling, see the DR Series System Interoperability
Guide.
IP addresses
•
Network values required are for IP addressing, Subnet Mask, Default Gateway, DNS Suffix, Primary (and
Optional) DNS server, and Host Name. If DHCP is selected, then these values are populated based on your
DHCP configuration. If DHCP is not selected, then these values must be manually configured.
NOTE:
It is recommended to use static IP.
•
Default values required are:
•
Default Static System IP: 10.77.88.99
NOTE:
Default static system IP is used only when there is no DHCP server. The default IP can be
used to configure the system using a point to point NIC connection.
All manuals and user guides at all-guides.com
Dell MD1400 storage enclosure components
(optional)
DR6300 Version Number Getting Started With Your System
•
System bezel (optional)
•
Power cables (optional)
•
SAS cables (optional)
•
RAID controller card (optional)
•
Pair of mounting rails (optional)
•
System documentation
Getting Started with your System
4
Publicidad
