Cub Cadet CC2090 Manual Del Operador página 5

APPLICATIONS
As a trimmer:
• Cutting grass and light weeds
• Edging
• Decorative trimming around trees, fences, etc.
As a brushcutter:
• Cutting weeds and light brush of up to 1/2 inch in diameter
Other optional accessories may be used with this unit. Refer to
Operating the EZ-Link System for a list of add-ons.
Brush
Blade
Gear Housing
Cutting Attachment
On some units, the J-handle may be pre-installed. In this case,
loosen the screws and go to step 5.
INSTALL AND ADJUST THE J-HANDLE
1. Place the J-handle between the top and middle clamp
pieces (Fig. 1).
(4) Screws
Bottom Clamp
Nuts
2. While holding the three pieces together, install the four (4)
screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up only
when assembled correctly.
KNOW YOUR UNIT
Shoulder Strap Clip
Blade Shield /
Shield Mount
EZ-Link™
Shaft
Housing
Cutting Attachment
Shield
ASSEMBLY INSTRUCTIONS
J-Handle
Top Clamp
Middle Clamp
Fig. 1
Starter Rope Grip
Shaft Grip
Throttle Lock-Out
On/Off Stop Control
J-Handle
Engine Stand
Line Cutting
Blade
3. Place the clamps and the J-
handle over the shaft housing
and onto the bottom clamp.
4. Hold each hex nut in the
bottom clamp recess with a
finger. Start screws with a
large Phillips screwdriver. Do
not tighten until you make the
handle adjustment.
5. Slide the J-handle in or out until
the arrow/white line on the decal
touches the clamp assembly (Fig.
2). You must first loosen the
screws if the handle is pre-
installed.
6. While holding the unit in the
operating position (Fig. 3),
position the J-handle to the
location that provides you the
best grip.
7. Tighten the clamp screws
evenly, until the J-handle is
secure.
Fuel Cap
Throttle
Control
Blue Choke
Lever
Air Filter/
Primer Bulb
Spark Plug
Decal
Fig. 2
Fig. 3
Muffler
Cover
Muffler
5