Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting Guide
SYMPTOM
Lights will
not come on.
Lights come
on in day-
light.
Lights come
on for no
apparent
reason.
Technical Service
Please call 1-800-858-8501 (English speaking only) for assistance
If you experience a problem, follow this guide. You may also want to visit our Web site at: www.hzsupport.com.
If the problem persists, call* for assistance at 1-800-858-8501 (English speaking only), 7:0 AM to 4:0 PM CST
(M-F). You may also write* to:
HeathCo LLC
P.O. Box 90045, Bowling Green, KY 42102-9045
ATTN: Technical Service
* If contacting Technical Service, please have the following information available: Model Number, Date of Purchase,
and Place of Purchase.
Please keep your dated sales receipt, it is required for all warranty requests.
598-1290-02
Get user manuals:
See SafeManuals.com
POSSIBLE CAUSE
1. Light switch is turned off.
2. Flood light is loose or burned out.
. Fuse is blown or circuit breaker is
turned off.
4. Daylight turnoff is in effect. (Re-
check after dark).
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
1. Control may be installed in a
relatively dark location.
2. Control is in Test. (Set control
switch to an ON-TIME position).
1. Control may be sensing small
animals or automobile traffic. (Re-
aim sensor or use lens shield).
2. Range is set too high. (Reduce
Range setting).
before returning product to store.
No Service Parts Available for this Product
SYMPTOM
POSSIBLE CAUSE
Lights stay
1. A lamp is positioned too close to
on continu-
the sensor or pointed at objects that
ously.
causes the sensor to trigger. (Aim
the lamp away from the sensor or
objects).
2. Control is pointed at a heat source
like an air vent, dryer vent, or brightly-
painted heat-reflective surface. (Re-
aim sensor or use lens shield).
Lights flash
1. Heat or light from the lamps may be
on and off.
turning the Light Control on and off.
(Aim lamps away from the sensor.
Turn Boost off).
2. Reflected heat from other objects
are triggering the sensor. (Re-aim
sensor. Turn Boost off).
. Control is warming up. (Flashing is
normal under these conditions. Wait
1 minute for sensor to warm up).
4. Control is in Test. (Set control switch
to an ON-TIME position).
-1-
Publicidad
