Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
UNPACKING AND CONTENT
IMPORTANT:
Due to modern mass production techniques, it is unlikely the tool is
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Drill/Driver
Wall Adaptor
Operator's Manual
OPERATION
WARNING:
To reduce the risk of serious personal injuries, read and follow all
important safety warning and instructions before using this tool.
:
NOTE
Always Check that the power supply corresponds to the voltage on the ratings
plate.
CHARGING THE TOOL (FIG 2)
• use only the Battery Charger that is included in this kit to
recharge your batteries.
• use only 120 Volt AC Power Source.
• Charge your batteries fully before using the drill for the first
time.
• Connect the wall adaptor (2) to charger stand (3)
• Plug the wall adaptor (1) into a 120 Volt AC Power Source. The
red light on the charger will illuminate, indicating the charger is
power on.
• Insert the battery (1) into the slot on the charger stand (3). Make
sure that the battery is seated firmly in the charger. The green
light on the charger will illuminate, indicating that the battery is
charging.
• Charge for 3 hours before initial use, and after normal use. If drill has been used continuously, and the battery
is completely discharged, it may require up to 5 hours to fully recharge the battery.
• The green and red lights will remain lit, even after charging is complete.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the drill, allow it to cool down to room temperature before charging.
This will extend the life of your batteries.
• Other tips for extending battery life: Do not store batteries completely discharged. Charge them fully before
storing, and if drill is not used for a long time, take the batteries out and charge them periodically.
WARNING:
Always disconnect battery pack from tool or place the switch in the
locked or off position before any assembly, adjustments or changing accessories.
WARNING:
Always be sure that the tool is switched off before insertion or
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY PACK (FIG 3)
• To install the battery pack, insert the battery pack into drill housing as shown in fIG 3. Always insert it all the
way until it locks in place with a little click. Lightly pull on the battery to ensure it is locked into place and will not
accidentally fall out of the drill, causing an injury.
• Do not use force when inserting the battery pack. If the battery does not slide in easily, it is not being inserted
correctly.
18V Cordless Drill/Driver
Operator's Manual
QTY
Description
1
Charger Stand
1
13-Piece Bit set
1
QTY
1
1
3
2
1
GCD18CP
FIG 2
Publicidad
