Descargar Imprimir esta página

Genesis GBG800L Manual Del Operario página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

aSSEMBLY aND aDJUSTMENTS
WaRNING:
from the power source before adjusting, adding accessories, or checking a
function on the tool.
Attaching and Adjusting Spark Guards and Eye Shields (FIG 3,4)
NOTE: Always check to ensure the eye shields are correctly attached and the spark guards are
correctly adjusted each time the grinder is used. eye shields and spark guards must be attached over
each grinding wheel.
There is a left and a right spark guard. Consult fIG 3 to
properly determine the mounting position of each spark guard.
follow the steps to attach the Spark Guard and eye Shield on
the LefT side of the grinder.
1. Insert Bracket Locking Knob (H) through a big lock washer
(M), a big flat washer (K), the eye shield bracket (B) and the
LefT spark guard (C), then screw into the hole in the left
wheel guard. Tighten sufficiently to hold the spark guard
and the eye shield bracket in place. (See fIG 3)
2. Adjust the spark guard to make its lower edge about 1/8"
(3.2 mm) away from the grinding wheel face. Rotate the
wheel by hand one revolution to ensure the wheel can rotate
without contacting with the spark guard. firmly tighten the
locking knob (H) to secure the spark guard and eye shield
bracket onto the wheel guard.
3. Insert the shield locking knob (G) through a star washer (N)
and a small flat washer (J) and the eye shield (P), and then
screw and tighten securely onto the eye shield bracket (B)
(see fIG 4)
Repeat the above steps to attach the RIGHT spark guard and
the eye shield on the right side of the grinder.
Attaching and Adjusting Tool Rests (FIG 5,6)
The tool rests are required for each high speed grinding wheel
to assist in the grinding operation.
WaRNING:
which tool rest has not been attached or where
the tool rest has not been correctly adjusted.
NOTE: There is a left and a right tool rest. The tool rest with
v-groove (e) is the left side tool rest (See fIG 5). When properly
mounted with the slotted portion of the tool rest bolted flush to
the tool rest bracket, the tool rest will be positioned directly in
front of the grinding wheel.
1. Hold the LefT tool rest (e) in the correct position against the tool rest bracket (2) on left wheel
guard (see fIG 6).
2. Insert tool rest bolt (O) through tool rest bracket (2) and tool rest (e), followed by a small flat washer
(J), a small lock washer (L), and the tool rest locking knob (I).
3. Tighten the locking knob (I) sufficiently to support the tool rest but still allowing the tool rest to slide
inwards and outwards.
8" Bench Grinder with Lights
Operator's Manual
always be sure that the tool is switched off and unplugged
Never use a bench grinder on
B
C
G
P
E
E
O
GBG800L
FIG 3
K
M
H
FIG 4
N
J
B
FIG 5
I
O
FIG 6
I
J
L
2

Publicidad

loading