KitchenAid KES6404BM Manual De Instrucciones página 20

REASSEMBLING THE MILK FROTHER
ATTACHMENT
1
Follow the steps of disassembly to
assemble again. Press the Black rubber
frother component into the main housing.
Insert the Milk dispenser tube in place and
push upward and rotate until it clicks.
TROUBLESHOOTING GUIDE
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
Problem
Espresso Machine will not
start
Espresso flows slowly or
only drips
All Mode/Dose lights are
blinking
20
WARNING
Electrical Shock Hazard
Check if the Espresso Machine is securely plugged into a
grounded 3 prong outlet.
Check to see if the Main power On/Off switch is turned on.
If you have a circuit breaker box, then make sure the circuit is
closed.
Coffee is ground too finely. Use slightly coarser grind.
Coffee tamped too hard. Use slightly lighter tamp between
30-40 lb or 15-20 kg of force.
Filter basket can be blocked. Use a pin to unblock the hole(s).
Machine might need to be descaled. Refer to the "Descaling the
Espresso Machine" section.
Machine is in protection mode to avoid the pump from over
heating. Turn Off the machine for 7.5 minutes.
2
Replace the Decorative plate.
Insert and rotate the Froth level
adjustment knob in its place.
Replace the Function knob in its place.
Solution