Samsung DVEG45R6300 Serie Manual De Instrucciones página 54

Maintenance
Keep the dryer clean to prevent decreased performance and to lengthen its life.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing.
Service Personnel - Do not contact the following parts while the appliance is energized: Control board and
inlet valve.
Vent sensor
The dryer features a vent sensor that detects and notifies you when it is time to clean the ductwork. The
indicator lets you know the status of the duct.
Level
Indicator
0 Off
1 On
2 Blinking
If the dryer is in the Level 2 state, the
cycle. If you press Power or open the door, the dryer powers off immediately.
NOTE
• For duct installation, see "Exhaust ducting guide".
• The dryer may keep running even if the duct is clogged, but the drying time will be extended.
• If the indicator turns on for the first time and is solid (not blinking), check and clean the lint filter and/
or duct.
• If the indicator turns on again later, it is because the duct is installed or connected with some
restrictions (it's too long or has too many bends). This is not a system failure. However, drying time may
be extended or the drying performance may be degraded.
54 English
Untitled-1 54
Status
The ductwork is not clogged.
• The duct or lint filter is clogged.
• The pressure applied to the duct
is high because the duct is too
long or bent.
• The duct or lint filter is severely
clogged.
• The pressure applied to the duct
is very high because the duct is
too long or bent.
indicator blinks for 3 hours after the completion of the current
Action
• Check the lint filter or duct and
clean if necessary.
• Check the duct connections and
shorten or straighten the duct if
necessary.
• Check and clean the lint filter or
duct and make sure they are not
clogged.
• Check the duct connections and
shorten or straighten the duct
work.
2022-09-05 10:28:50